June 2020

Corrosion in Pre-GI and Hot Dip Galvanized (HDG) Structures

By |2020-07-07T09:50:54+05:30June 29th, 2020|

Please have a read of the below article from Nuevosol which talks about corrosion in Pre-GI and Hot Dip Galvanised (HDG) Structures. Salient points are as below: Nuevosol article Pre-GI can be used as long as it is 550 GSM steel. The galvanization coating thickness is a maximum of 20 micron each side for [...]

Comments Off on Corrosion in Pre-GI and Hot Dip Galvanized (HDG) Structures

CAT6 and RS485 cables for communication

By |2021-09-22T08:19:57+05:30June 29th, 2020|

Basics A CAT6 cable can theoretically carry data for 100m but after 80m, there would be signal attenuation and it would be impractical. So 80m is the practical limit for CAT6 cables. An RS485 cable can carry data upto 4000ft (or 1.2km) @ 100kbps as shown below. If you need more information on the [...]

Comments Off on CAT6 and RS485 cables for communication

Can DC and AC cables run in the same conduit?

By |2020-06-29T11:58:08+05:30June 29th, 2020|

We have been asked a few times in the recent past as to whether we can run DC and AC cables run in the same conduit.The answer is No since the DC cables could induce a DC voltage onto the AC side. The AC sine wave should oscillate about the 0 volt axis i.e., the positive and negative [...]

Comments Off on Can DC and AC cables run in the same conduit?

Optimum tilt angle for fixed panels

By |2020-06-08T10:58:03+05:30June 8th, 2020|

Solar panels generate the maximum output when the sun-light falls perpendicular on the panels. However to achieve the ideal harvest of solar energy, you need to have a multi-axis tracker which throughout the day and throughout the year face the sun and try to maximize the generation. The only disadvantage with such a system [...]

Comments Off on Optimum tilt angle for fixed panels

Solar Window Period

By |2020-06-08T10:39:48+05:30June 8th, 2020|

Overview Almost in all meetings, we have noticed that clients require clarification on the placement and orientation of panels. Particularly, clients have pointed out that shadows are falling on panels at 5PM or early morning at 7AM. In this regard, it is imperative upon the EPC to educate the client on the solar window [...]

Comments Off on Solar Window Period
Go to Top